藥敏試驗的操作注意事項有哪些？
發布時間：
2022-12-24
作者：
國內比較有名的培養基公司
1，培養基的厚度對抑菌圈的大小有影響，故平皿中加入培養基要固定，以4毫米深度為宜。制備的平板使用時應放于35℃溫箱中30分鐘去除過多的水分，以免影響抗菌藥物的擴散。
2，接種細菌后應在室溫放置片刻，待菌液被培養基吸收后，再貼紙片。但不宜放置太久，否則在貼紙片前細菌已開始生長可使抑菌圈縮小。
3，培養溫度為35攝氏度為宜。堆放試驗平板不超過兩個，使其受熱均勻。
4，測量抑菌量應仔細，精確，從生長刺激帶測量。
What are the precautions in the operation of drug sensitivity test?
1. The thickness of the medium has an effect on the size of the bacteriostatic circle. Therefore, the medium should be fixed in the plate, and the depth of 4 mm is suitable. The prepared plate should be placed in a 35 C temperature box for 30 minutes to remove excessive moisture so as not to affect the spread of antibiotics.
2, after inoculation, the bacteria should be placed at room temperature for a moment, and then the bacteria liquid is absorbed by the medium and then pasted with paper. But it should not be placed too long, otherwise the bacteria will start to grow before the paper is pasted, so that the bacteriostatic circle will be reduced.
3, the incubation temperature of 35 degrees Celsius is appropriate. There are no more than two plates in the stacking test flat, so that the heating is uniform.
4, measurement of bacteriostatic dose should be carefully and accurately measured from the growth stimulation zone.